Has anyone fitted one of these.....I have looked on here for the wiring diagram and cant find it ....2007 dyna superglide....cheers wingnut.

If you're buying a new one it will most likely have a wiring diagram with it.

Wiring diagram is shit it even has a pic of a distributer on it ........I was told I just had to splice the wires to behind the speedo.......says its for 2cyl   4stroke (correct)  red wire to ign on (ok) black wire ground(ok) green wire to negitive terminal of coil (??????)      I was told it definitly 100% will fit my bike......time to give up for now and have a few oyzo's...cheers.

My bike is 01 FXDWG .

My tacho hooked up to a pink wire under the console that is not always shown on wiring diagrams.

My set up is analog but yours will be wifi?however the pink wire has a plastic end on it.

this is how i done mine    baron tacho  onto 07 fxst

black--- earth

green--- designated port in ecm--------number 3--------thread wire first then fit terminal--part  72076-00------about $2-----pull back to lock

blue and red--------- join together--------- then join to------blue wire from taillight loom

hope this helps

Thanks guys .....harley instructions are shit to read or I am a dumb ass...this is what I found out and hope it makes it easier for the next bloke......cheers wingnut.

" />Remove blue locking pin

" />Then remove red blanking pin

" />Orange / white trace to red tacho wire

" />Shit photo but shows only black wire to black to tacho wire

" />Does not show female Deutsch connection fitted.......Dick Smith not open on Sunday

" /> Tacho position

I will take another pic when I get the Deutch fitting and wire up the tacho light.......but it does work and yes it does read 12000 rpm the 8000 rpm tachos are no longer available in 48 mm.

Looks sweet.

Glad it worked out for ya.